|
|
Suggested definition of 'differences' to be shown by tuneDisplay for various devices:
|
|
|
|
|
|
* Quads (both magnetic and electrostatic): The percent difference between the quad's calculated setpoint (current or voltage) and its actual setpoint. `Diff = 100*(calc_setpoint - actual_setpoint)/calc_setpoint`
|
|
|
* Steerers: the difference will be the difference in steering between the current and calculated setpoints, divided by
|
|
|
* Magnetic dipoles: The percent difference between the dipole's calculated field setpoint (gauss) and its actual setpoint `Diff = 100*(calc_setpoint - actual_setpoint)/calc_setpoint`
|
|
|
* RF phases: The difference between the calculated phase setpoint (gauss) and its actual setpoint, normalized to 180 degrees `Diff = 100*(calc_setpoint - actual_setpoint)/180`
|
|
|
* RF amplitudes: The percent difference between the calculated amplitude setpoint (units unspecified) and its actual setpoint. `Diff = 100*(calc_setpoint - actual_setpoint)/calc_setpoint` |
|
|
\ No newline at end of file |
|
|
* Quads (both magnetic and electrostatic): The percent difference between the quad's calculated setpoint (current or voltage) and its actual setpoint. `Diff = 100*(actual_setpoint - calc_setpoint)/calc_setpoint`
|
|
|
* Electrostatic steerers: the difference will be the actual steering voltage (steerer setpoint minus common plate setpoint) minus the calculated steering voltage (steerer setpoint minus common plate setpoint), divided by the the full scale of the steerer supply (1000 V for most steerers in ISAC), multiplied by the maximum source voltage over the actual source voltage. `Diff = 100*[(actual_steering - calc_steering)/steerer_range]*(max_source_vol/actual_source_vol)`
|
|
|
For a typical ISAC electrostatic steerer this becomes:
|
|
|
`Diff = 100*[(actual_steering - calc_steering)/1000]*(60/actual_source_vol)`
|
|
|
* Magnetic dipoles: The percent difference between the dipole's calculated field setpoint (gauss) and its actual setpoint `Diff = 100*(actual_setpoint - calc_setpoint)/calc_setpoint`
|
|
|
* RF phases: The difference between the calculated phase setpoint (gauss) and its actual setpoint, normalized to 180 degrees `Diff = 100*(actual_setpoint - calc_setpoint)/180`
|
|
|
* RF amplitudes: The percent difference between the calculated amplitude setpoint (units unspecified) and its actual setpoint. `Diff = 100*(actual_setpoint - calc_setpoint)/calc_setpoint` |
|
|
\ No newline at end of file |