... | ... | @@ -5,6 +5,10 @@ Suggested definition of 'differences' to be shown by tuneDisplay for various dev |
|
|
`Diff = 100*[(actual_steering - calc_steering)/steerer_range]*(max_source_vol/actual_source_vol)`
|
|
|
For a typical ISAC electrostatic steerer this becomes:
|
|
|
`Diff = 100*[(actual_steering - calc_steering)/1000]*(60/actual_source_vol)`
|
|
|
* Magnetic steerers: the difference will be the actual steerer current minus the calculated steerer current, divided by the the full scale of the steerer supply (6 A or 200 A for most steerers in ISAC), multiplied by the maximum beam rigidity (Bp) at that location over the actual beam rigidity (Bp).
|
|
|
`Diff = 100*[(actual_steering - calc_steering)/steerer_range]*(max_source_vol/actual_source_vol)`
|
|
|
For a typical ISAC electrostatic steerer this becomes:
|
|
|
`Diff = 100*[(actual_steering - calc_steering)/1000]*(60/actual_source_vol)`
|
|
|
* Magnetic dipoles: The percent difference between the dipole's calculated field setpoint (gauss) and its actual setpoint `Diff = 100*(actual_setpoint - calc_setpoint)/calc_setpoint`
|
|
|
* RF phases: The difference between the calculated phase setpoint (gauss) and its actual setpoint, normalized to 180 degrees `Diff = 100*(actual_setpoint - calc_setpoint)/180`
|
|
|
* RF amplitudes: The percent difference between the calculated amplitude setpoint (units unspecified) and its actual setpoint. `Diff = 100*(actual_setpoint - calc_setpoint)/calc_setpoint` |
|
|
\ No newline at end of file |